Garage door opener repair is important if you’re suddenly unable to open your garage door. Our team of experts provides great service and repair on all kinds and models of openers including Lift Master, Sears, Craftsman, Chamberlain, Genie, Stanley, and Wayne Dalton.
Automatic openers save us from having to truly get out of the car to manually lift and open the door. With them, we simply push a button and drive right in – unless the opener doesn’t work.
How you’re Garage Door Opener Works
A garage door opener is an electrical motor appliance that opens a garage door at the push of a button. The button is often one that’s wired into the household circuit or one that’s on a battery-powered remote-control unit usually carried during a car. Most garage door systems have both. The button sends an infrared or radio wave to the control unit that, in turn, activates an electrical motor with a track-and-pulley system that moves the door. Most garage door opener units even have a light-weight that goes on automatically and shuts off after a pre-set interval.
Garage door opener repair can vary widely in scope, from the only thing like replacing the batteries within the remote opener, to adjusting the drive and pulley system, to having to exchange and/or rewire the whole system.
They’re a spread of problems which will occur together with your garage door opener:
- The opener might not respond when the remote or wall button is pushed.
- The opener may raise the door but not close it.
- The opener may run but not open the door.
- The opener may operate without a command.
- The door might not open or close completely.
- The door may reverse when closing.
- The opener may need to work too hard.
Routine maintenance can prevent tragedies. Take a couple of minutes to examine and test your garage door opener system. For the security of your family and yourself, make a monthly inspection and testing a neighborhood of your regular routine.
Reversal Test
Make sure your opener features a reversing feature. If a reversing feature isn’t present, it should get replaced. Garage door openers manufactured after January 1, 1993, are required by federal law to possess advanced safety features that suit the newest U.L. (Underwriters Laboratory) 325 standards. Test the reversing feature monthly. If it’s not functioning properly, call us for this critical garage door opener repair immediately to stop any injuries.
First, test the balance of the door. If the door is correctly balanced, then proceed.
With the door fully open, place a 1-1/2″ thick piece of wood (a 2″x4″ laid flat) on the ground within the center of the door.
Push the transmitter or wall button to shut the door. The door must reverse when it strikes the wood.
(Note that rock bottom a part of “one-piece doors” must be rigid in order that the door won’t close without reversing.)
If the door doesn’t have reverse, have it repaired or replaced. Call our team of execs to regulate, repair, or replace the opener.
Force Setting Test
Test the force setting of your garage door opener by holding rock bottom of the door because it closes. If the door doesn’t reverse readily, the force could also be excessive and wish to adjust. Call us to perform this important garage door opener repair. We’ll then test the reversing feature after any adjustment.
Additional Safety Devices
Many garage door openers are often equipped with additional safety devices. If one isn’t already installed, consider adding a photo eye or edge sensor as an additional measure of safety to stop entrapment. Confine mind that adding more safety devices won’t make an old opener meet current U.L. standards. As a part of the garage door opener repair, we’ll make sure that the extra safety devices are properly installed and adjusted.